Carlon Programmable Timer Controls

Carlon Programmable Timer Controls have wide applications. Timers control the length of the signal needed to operate chemical feed pumps, valves or other equipment long enough to perform the operation needed in the water treatment system. Typical Timer systems use the pulse signal from a JSJ Series Electric Contacting Meter, to activate the Timer(s) in the control cabinet. The Timer(s) sends a timed output signal (adjustable) to a chemical feed pump, solenoid valve or water softener as determined for the application.

Offering These Advantages

• Chemical feed in direct proportion to water used

• Automatic compensation for variations in water flow

• Easy adjustment of the desired length of the timer output signal

• Reliable solid state circuitry

• User choices for sequencing and timing units needed

Specifications

• Dry Contact normally open switch closure activates timer(s).

Product Details

PTC Series – Controller Selection Chart

Meter Mounted Timer Controls – ST & DT Series

Carlon Mounted Meter/Timer Systems offer the most complete, economical and convenient system available for controlling chemical metering pumps, valves or other equipment. Installation is easy! Just install the meter, plug in the 120 volt power cord, and plug the unit to be controlled into the receptacle on the timer. The meter is pre-wired to the Timer Control. This Control is also available with two timers in our DT Dual/Timer System for controlling two units at one time.

Offering These Advantages

• Carlon Electric Contacting JSJ Series Water Meter
• Carlon Lower Cost Timer
• Standard Dual Receptacle for pump, valve or other units
• Total Output Rating for up to 15 AMP resistive @ 120 V
• Timer Setting available in seconds or minute increments
• Meter is Pre-wired to the Timer Control

ST & DT Series

PTC Series – Controller Selection Chart

Downloads

Product Specifications
Program Manual