IP100/200 Series Impeller Flow Sensors

IP100/200 Series Impeller Flow Sensors

The IP100/200 series impeller flow sensors are adjustable depth insertion paddle-wheels that come in brass or 316 stainless models to fit 3” to 48” pipe. Installation fittings are standard 1-1/2” (101/201) NPT. Fittings such as saddles and weldolets may be purchased either locally or from AquaMetrix.

Ruby bearings and a non-drag Hall-effect sensor give these meters the widest flow range of any of the paddle-wheel types. A sensor detects the passage of miniature magnets in the six rotor blades. The resulting square-wave signal can be sent for hundreds of feet over unshielded cable without a transmitter and connected directly to many PLC’s and other controls without any additional electronics.
The Shark-120/240 controller or SharkTX/P transmitter (loop powered) models provides digital rate and total display, as well as single or dual 4 to 20 mA analog output.

Features

• Low-friction, long-life jewel bearings

• Single moving part

• Six bladed impeller

• Fully field-repairable

• Choice of stainless steel or brass

• Integrated Tee and sensor

• Fits 1/2” to 8” pipe sizes

• Fixed depth in fitting ensures proper placement in pipe

• High level signal can be sent up to 2000 feet

• Each fitting individually calibrated and marked with K-factor (Pulses per Gallon)

Applications

• Wastewater flow

• Water Treatment systems

• Irrigation

• Groundwater remediation

• Chemical Mixin

• Process cooling system

• Neutralizaton Systems

• Process flow control

• Filtration systems

IP100/200 Series Impeller Flow Sensors Datasheet