Sure Cross® Performance Board Modules

Performance Board Modules

The PBx board-level Nodes and Gateways can be used in pairs to quickly and easily replace discrete or 4 to 20 mA signal wire.

• Inputs on the PB2 Gateway can be mapped to outputs on the PB2 Node using DIP switches instead of the User Configuration Tool; inputs on the Node are also mapped to outputs on the Gateway

	Performance Board Module

Gateways

Model	Frequency	Supply Voltage	I/O	Quick Start Guide	Datasheet
DX80G9M6S-PB2	900 MHz	10 to 30 V dc	Inputs: Two PNP discrete, two 0-20 mA analog Outputs: Two PNP discrete, two 0-20 mA analog	164886	163211
DX80G2M6S-PB2	2.4 GHz

Nodes

Model	Frequency	Supply Voltage	I/O	Datasheet
DX80N9X2S-PB1	900 MHz	10 to 30 V dc, solar, or battery power	Inputs: Two NPN discrete. two 0-20 mA analog Outputs: Two NMOS discrete Switch Power: Two	163210
DX80N2X2S-PB1	2.4 GHz
DX80N9X6S-PB2	900 MHz	10 to 30 V dc	Inputs: Two PNP discrete, two 0-20 mA analog Outputs: Two PNP discrete, two 0-20 mA analog	163212
DX80N2X6S-PB2	2.4 GHz

Mapping Inputs and Outputs

DIP switch settings automatically map inputs and outputs between the Gateway and one or two Nodes in the following pattern.

PB2 Gateway to PB2 Node I/O Mapping

When using a PB2 Gateway and one PB2 Node, the DIP switch mapping option automatically maps the Node's inputs to the Gateway's outputs and the Gateway's inputs to the Node's outputs.

PB2 Gateway to Two PB2 Nodes I/O Mapping

When using a PB2 Gateway and two PB2 Nodes, the DIP switch mapping option automatically maps the inputs from both Node 01 and Node 02 to the Gateway's outputs and splits the Gateway's inputs between the two Nodes' outputs.

Additional Information

For a basic description of how antennas work, how to connect a remote antenna system, and the differences between omni and Yagi antennas, refer to Antenna Basics. There are many possible installation configurations for your wireless network.